WTB 1 3/8 input shaft for nv4500

[95cummins5.9]

Finally spun the center out of this junk LUK clutch. Need a flywheel.

 

[Mark Nixon]

Is there a part number on these flywheels?
I have a South Bend flywheel here that's a 13", but I am not sure if it is what you need.

Mark.

 

[95cummins5.9]

I will give Peter a call tomorrow and find out. Is it in pretty good shape?

 

[Mark Nixon]

I recently removed it from a 1993 VE engine, but I think it's the same flywheel as a 2nd gen SB flywheel.
It has the same lame looking pressure 13" LUK plate and disc with the really narrow track.

It was barely even ran, maybe 5k miles and only a little searing on the pressure plate.
As far as I'm concerned, the disc and PP is scrap metal.

Mark.

 

[95cummins5.9]

Well, the clutch is fine. The input is snapped though! So a 1.375 is on the list instead.

 

[Mark Nixon]

I was just perusing SB's site and they show both the '88-'93 and the '94-2003 lighter duty kits as being the same.
I think the 4th option on the 1994-'03 is only different because it's for an 1-3/8" input in an NV4500.

1988-'93: South Bend Clutch - 13-1.25 Con OFE
1994-'03: South Bend Clutch - 13-1.25 Con OFE

Mark.

 

[95cummins5.9]

I was just perusing SB's site and they show both the '88-'93 and the '94-2003 lighter duty kits as being the same.
I think the 4th option on the 1994-'03 is only different because it's for an 1-3/8" input in an NV4500.

1988-'93: South Bend Clutch - 13-1.25 Con OFE
1994-'03: South Bend Clutch - 13-1.25 Con OFE

Mark.

You any help with a 1 ⅜ input?

 

[Mark Nixon]

Actually, yes I can help.
I have a nearly new one here, not sure what brand it is, no markings.

Mark.