Recent content by arinkuddy

Has anyone ever found or used a rail pressure relief valve that pops at like 30kpsi or there abouts? My factory RPRV is getting weak. I thought about getting a block off plug but I would like to keep some sort of safety net. I think everything would be safe as long as the regulator functions...

Question I'm looking at the 362SXE turbo on industrial's site. I'm guessing the 64/68 is going to spool faster because the turbine has the most weight and is smaller but that's a guess. For anyone with experience, which one will spool faster and why would you pick one over the other? I have a...

so the base timing table is the one i have highlighted. also the stock 5.9 timing wouldn't run a single injection tune, i think about a min of 5 deg is whats required to run on my truck with a warm engine. cool project btw!

So I am wanting to add more fuel to my 06 and I have been looking at Exergy's products. The reason I want to go with them is just because they have good flow data for their injectors that I can use in my tune. From what I figure I need 100% over to get approx 600hp. If I understand right 100%...

I've been running this which my truck seems to like I cruise in the 40-45mm3 range on level road so im pretty much running about 8.5* of timing there. I think 10* is getting a bit high for the 45mm3 cell. I dont have enough data to say for sure but looks promising. I can say this table did not...

I'm wondering what is the most main timing you guys are running in the cruise region for the 5.9. Right now have it around 11° and pilot is starting around 17°. I'm just breaking into the 20 mpg area with like 600° egts. Any input is appreciated.

I'm looking for the crank radius and the rod length for a 3rd gen cummins. I was wondering if anyone had any documents or knew these dimensions. I'm making some calculations for EFILive and am trying to maximize efficiency and also find hard limits so I'm not tuning in the dark. Right now I have...

So dad is looking to buy a used magnum probably 71 72 or possibly a 89 series. We just tore up the rear end and hydraulic pump in our 1486. I was doing a little research for him and I was wondering if there were any problems too watch out for. The 8.3 CDC motor seems pretty good in our combine...

I made a excel calculator for displaying the wheel speed with your given transmission, xfr case, rear end, & tires. I wanted a way to decide what gear to pull in and so i made a table which tells what rpms i need to get 20 - 30 mph. I figured since I took the time to make it for mine I would add...