Hey guys, What are the best sleeves when building a 6.7 deck plate engine, and where is everyone getting them from? With the deck height being an inch taller are the sleeves longer as well?
Thank you
Those of you running full hydro steering and an electric hydro pump, are you still plumbing the electric pump into the factory brake booster the same way it would if you were still using the factory power steering pump? This is on a 97 dodge
Thank you
Looking into putting electric over hydraulic steering on my 3.0 truck I’m building. Which size Ram are you guys using? This is on a dodge second gen. 2.5” bore by 8” stroke? Also if you could point me in the right direction for a good orbital valve and a electric pump that isn’t overly...
This is for the guys who are running coil over shocks inside the factory springs on a second gen dodge. What length and model of shock are you guys running? Just wondering how much stroke I should look at and spring rate. I know spring rate will be pendant on how much weight I’m hanging...
I just wanted to comment and say thank you for this site and to a lot of the people on it. Building a 3.0 truck has been a new adventure for me and the people on this site are extremely friendly and helpful, I’ve asked a million questions looking for help and advice and you all do the best you...
Any one have a manual hub conversion kit for a dodge Dana 60? Must be 35 spline stub shafts. Doesn’t have to be the ems brand, trying to save a little coin over buying brand new. Thanks
What diameter/wall thickness are you guys using for drive shafts on a 3.0 truck? Drop box and rear is set up for 1610 joints and the front is set up for 1480 joints.
I want to build it right the first time so I can eliminate broken parts as much as possible.
Thanks for your help
I have a question for those of you who have ran a drop box behind an nv4500. How much of an angle to the driver side of the truck are you putting the drop box? This will be in a 97 12 valve dodge, Extended cab long bed. Waiting for my box to show up then I want to start getting it...
Looking for a trex girdle or girdle without the studs. I already have 14mm studs. Was hoping for a trex girdle but he is behind and not sure when he can get more made so I’m looking for good used in the mean time. For a 12v Cummins engine
Looking for a good used profab drop box. No one inch gear boxes, it’s going in a 3.0 limited pro Cummins. Please just private message me
Thanks for your time