Recent content by roachie

Anyone know jack squat about these? It looks suspiciously like an onan. My jeep needs more power is why I ask.

Just wondering if anyone has seen a successful swap with the pair? Last I was told no one has made it work.

I had a computer crash and lost all my notes on this. There was a discussion on this year's ago about the 6.7 12v found in agco tractors. I'm trying to get the ESN to pull pistons and rod measurements. From what I remember a 450ci engine is possible with this crank and the normal 6.7 block.

Ive never seen how the ends are installed on them, and have a build coming up that may need a really custom set. So, does anyone know how it is done?

Swapping an 08 6.7 into a SD for a guy that bought my short bed truck. It is wired up with like this. Can C bus (+) to pin 6 on the OBD 2 connector Can C bus (-) to pin14 Both of these are straight off the ecm into the connector. I can read codes and clear them with an autocal but it will...

My system isnt showing any repair history for some damn reason. 1FDWW37P14EC48310

I cannot find a damn thing in my area, or on ebay. Needs to be 4x4 Crew Cab Not rusted out not wrecked horribly Engine is not an issue, really dont even care if it has one. Base model work trucks will work.

I have a complete setup for an auto. Flywheel housing Starter Flexplate Bolts Also have a CORE 47RE 4x4 with the converter. Guy said it was burned up, I haven't opened it up so it is a mystery box. I would like to trade it for a complete Ford T19 setup with the bellhousing if possible...

I've got other stuff I want to finish more than this one. 2001 XL 5.4 Auto Two wheel drive Tan lariat interior with 40/20/40 xlt seat. Runs and drives, needs body work and paint (obviously). Could negotiate the body/paint complete for the right price $3000 Things you should know...

I've borrowed my step dad's truck to install a surprise Christmas present, a stage 2 denny T pin. Drive around town fine for a stock VE. Get to shop and install pin, truck will not get over 40 mph. Zero smoke under load and revving. Even with the pin out of the truck it will not even let out a...

Take a pair of V8 heads, cut a cylinder off each one, weld the remaining into an online 6 head....... Can it work

Short version, me and Atchley live in the hills of TN will too much shine and free time. We want to turbocharge our John Deere 430 garden tractors, not for pulling, just for more useable power. We would like to bump it to 30hp from the factory 20. Yanmar 3TNA72UJ 3-cylinder, liquid-cooled,885...

So I bought this truck with cab lights, it's a regular cab F250. Unless I change my name to Jose' and plaster a virgin mary on the back glass cab lights have no place on a 2wd reg cab short bed. Other than replacing the roof skin, or welding up the holes, has anyone come up with a good solution...

Ive read a lot of speculation and have thus far been unable to find any concrete info. What parts combos have done this on fuel only? Best I can tell a 14mm head, retarded injectors, and a very very good supply system. Air would be supplied by the standard HX35/HT3B set.