12v injector puller tool?

[9712valve]

anyone sell these or know where I can buy, it's not something I need very often but when I do need it sucks having to drive an hr to go borrow it from the guy who did my tranny. I asked him where he bought it and he said it was such a long time ago he can't remeber. this works much better then pry bar which.

 

[cummins freak]

small piece of pipe and one of your lug nuts about $0.10

 

[fordcummins01]

I think Jessup has some pretty trick one he supposedly has a patten on...but, as mentioned..do it cheap

 

[jaybuller]

i thread a metric lug nut down on the injector then clamp a pair of vice grips to the lug nut sideways and then use a regular old pry bar leveredgged off the headbolt head right infront of each injector... pops right out and works like a charm.

 

[Lower]

Get a baby slide hammer and weld a lugnut to the end.

 

[9712valve]

This is the tool im talking about

 

[cummins freak]

you guys a piece of pipe cut to a length so a lug nut screws on to a couple of threads works great. you just keep tightening the nut down on the injector nad it will just pop out works slick

 

[RJM06590]

^^ yep works great

 

[kalder]

This is the tool im talking about

I made one just like that!

 

[ride42]

Lug nut + pvc + fat washer = injector puller.

 

[SSpeeDEMONSS]

i used a small piece of EMT cut to length and a lug nut like everyone says.

Garrett

 

[Kronic_187]

lug nut and small pry bar, it's not hard.....

and if there c^nty like your old lady, just give it an open palmed wack