You guys offer a 3rd gen outlet race cover for a factory BW S366??
~Les
Don't think we have them for the angled covers. On the dyno though we have not picked up any power with the S300 "race cover" though. Stick with the cover that is on that turbo.....plain and simple it works. If you really want one though we can source one for you, but I would pocket the money for an upgrade later down the road.
My problem is I keep blowing 90* boots...I use this boot to connect the compressor outlet to my 3rd gen intercooler pipe...figured if you had a 90* outlet cover...i could keep it together better.
~Les
On the dyno though we have not picked up any power with the S300 "race cover" though.
When the s300s are run on low pressure setups (gas motors high rpm etc.) do the race covers for the s300 still not produce any additional power?
correct me if im wrong but isnt the third gen outlet s366 part number 177284 vs the 2nd gen s366 177275?
Not much from what we have seen. We are picking up the power on the turbine sides more then anything else.
Don't think we have them for the angled covers. On the dyno though we have not picked up any power with the S300 "race cover" though. Stick with the cover that is on that turbo.....plain and simple it works. If you really want one though we can source one for you, but I would pocket the money for an upgrade later down the road.