SPEEDSHIFT
New member
- Joined
- Jan 30, 2007
- Messages
- 5,978
I am debating on O-ringing my CR block with my Isky O-ring tool and wanted to see what you guys run for wire protrusion with the MLS gaskets. I use the thicker MLS gasket, I believe its .015" thicker.
I use .035 wire and usually run a .015" wire protrusion but that was on 24v/12v gaskets, I didnt know if it should be different on a MLS gasket.
I dont have time for fire rings as I am in a rush, need to have it done by tomorrow evening. So its either O-ring the block or leave it alone and just install a new gasket.
I appreciate any advice!:Cheer:
I use .035 wire and usually run a .015" wire protrusion but that was on 24v/12v gaskets, I didnt know if it should be different on a MLS gasket.
I dont have time for fire rings as I am in a rush, need to have it done by tomorrow evening. So its either O-ring the block or leave it alone and just install a new gasket.
I appreciate any advice!:Cheer: