Recent content by 2004cuminz

Have a set of carrillo rods used in the hybrid kit. New never been installed. No pistons just the rods. 2k obo shipped

Looking for a t4 1.0 housing for my 476/87

I. Could use a schematic or pic of the harness for an anteater non pro. Mainly the wires that go in the black box from the controller. 3 wires pulled out on mine and i need to figure out which go where so i can fix it.

So i changed my injectors. Truck fires right up but has a hesitation and sometimes will just want to take off like all the power Is coming in. Could the tps cause this without throwing a code. I was having it throw codes before. Or could it be a connector tube? Also changed tunes as i went to...

Just bought a 2008 cab and chassis. I bought it for the engine. From what i found it would have an aisin trans in it. Its just 2wd what would the trans be worth sold as a core?

So i can get a 6.7 sleeved by a reputible shop for 150 a hole and cam bearings throughout for 400. Is this a decent price? Also i will have to buy the sleeves. Tried calling powerbore but havent heard anything.no limit said 200 a peice. Whohas used no limits sleeves and how do you likes them? Im...

So im wanting to lighten up my qcsb.spare tire is gone tailgat mia. How much weight can be lost by gutting bed down to bedsides. Going to put a rollpan on and get rid of rear bumper. Also take my receiver off. May get a fiberglass hood also. I got a sport bumper but it seems as heavy as the...

Anyone used a 76/87/.90 on the manifold as a compound setup

Looking for a 6.7 block near northern missouri

Im looking for something that will handle 1250on fuel and 1500 on nos will a 5.9 block on a single handle it or should i just go with a sleeved 6.7 and make a 6.4

Got on my truck today started spinning at about 50 then heard a noise and tranny has nothing but park. Thinking my input shaft broke. How bad does it tear up other stuff if thats what it is. What else could it be if not input?

I have 4.10 gear ratio looking for a set of radials for next season. On my all season tires i cut a 1.64 60ft trapped 7.20 at 97.11 in the eighth. Thinking slicks and im gonna get rid of back bumper and put just bedsides on for next year. What size radial should i run with my 4.10 gears have a...

Is ronnie still doing injectors

Looking to trade my ii 170% over for a set of 250% over injectors

Looking for a 76/87/1.0