Recent content by CT2500

Looking to up grade my front drive shaft. Is it possible to get away from using the cv joint? From what I've read a 1410 ujoint has a greater working angle than a 1350. Any info would be appreciated thanks Scott.

Hey guys Iam looking for a dana 80 open 4.10 carrier. Thanks scott

Looking for a 2.6 cover for a s480 with vband flange. Thanks scott

brand new in box frozenboost type 17 air to water intercooler $280 core 160 ppump $350 new recon holset HT60 $750 12v wh1c turbo $200 pioneer avic N2 navi with xm box ipod cable $300 second gen center cap for aluminum wheel $30 third gen center cap for aluminum wheel $30 12v stock intake...

Looking for a Dana 80 open carrier with spiders. 3.73 or numerically lower has to fit 3.55 ring gear. thanks scott

does anyone know if the damper for a 24v comes with timming markes? ATI - Super Dampers Diesel Engines

got around to pulling off my afc today hooked up a regulator with shop air and saw what was goin on. the foot started to move with a 1/2psi and was all the way out at 14psi. I have read that this is my starting point. what numbers should i see when its adjusted correctly? the reason for checking...

hey guys just got my ppump conversion done pretty happy with the resaults so far. Did a little burnout yeseterday and right when the boost startes to come on iam getting this pop and then it goes away. iam going to try to upload a vid and you can see. engine is timed to 26* 160 pump 4gsk 191...

has anyone had a pump glass beaded and then spryed with clear coat? looking for longterm resualts.

hey guys iam running a set of DDP 4 and iam wondering what the spry angle is on them. truck is a HO and in the process of p pumping it just tryin to figure out how much timing before its sprying out of the bowl. Thanks -Scott

how much timing will a HO engine handle without sprying out of the bowl?

-------------------------------------------------------------------------------- I have got a good running vp44 HO that came off my truck. $500 good working APPS only 1yr old $150 vp fuel lines $50 94-02 intercooler, intercooler tubes, stock boots and all the clamps $250 94-02 motor mounts...

What size fuel line you guys runing to the IP.

A friend of mine just purchesed a BD turbo mount exhaust brake. the truck is a stick just curious how long install will be checked out the directions on the website looks pretty straight foward. Thanks scott.

I am selling edge drag comp 01-02.$350 Quad ADR1001 with control pod $450 two 10" MTX subs and box that fit under rear seat of a ext cab.$150