Recent content by LiftedBlackHD

  1. L

    Need opinions on coolant leak/possible EGR cooler

    I noticed recently I had high egt's which I thought was due to the Atlas 40 FICM that I recently installed. I was seeing 1100 cruising at 70 mph. I had a Cat on my truck so I removed it which dropped the temps but not significantly. Then I thought maybe there's an exhaust or boost leak. Boost...
  2. L

    5.5" Fabtech lift for 99-04 Superduty

    I am selling the lift that I recently removed from my truck. It will fit 99-04 Superduty's. The kit includes all four leaf springs, 4 DR signature series shocks, and the trac-bar drop bracket. $ 500 + shipping or local pick-up.
  3. L

    Pro Comp Extreme A/T or Toyo M/T

    I've narrowed my search to these two tires. 95% of my driving in on the road, with the occasional trip to the sand or snow. I want 38's. Help me choose... :bang
  4. L

    Icon/Deaver

    I am getting ready to go from a 5.5" fab-tech set up to an 8" Icon. I have a couple of questions. For the best possible ride would I be better off purchasing the Deaver springs seperately or do the Icon springs ride just as good? Also If I go with the 8" front and 5" rear springs will I be able...
  5. L

    04 F250 Harley Davidson 4x4 SC LB

    Selling this truck is going to be very hard for me. I have a lot of time, work and money in this truck but I just can't afford it any longer. It has about 72K miles on it. Oil changed every 5k and fuel filters every 10k. Oil analysis come back excellent! It doesn't leak a drop of oil. It runs...
  6. L

    DTC's after installing 05+ intake elbow.

    I am getting a p0488, p1334 and a CEL after installing an 05+ aftermarket elbow on my 04. Can You solve this issue with the SCT? Thank You
  7. L

    Is this an ICP issue?

    I've been experiencing symptoms for the last few months that I believe are caused by an ICP failure. Idle bouncing from 500-800 the ocassional surge/uncommanded jump in rpm's and it even died 3-4 times. The symptoms are consistent with everything that I have read in regards to a bad ICP. I...
  8. L

    Wheel fitment problem

    To make a long story short...I bought some new wheels, went to have them mounted and due to the width and offset of the wheel they rubbed on my front bumper considerably. If I just had the gray unpainted bumper I would have cut it no problem. However I have the Harley bumper and I'm not...
  9. L

    20 x 8.5" Eagle Alloy Series 114 (8x170)

    I just purchased some new wheels for my truck and am selling the old ones. These wheels are in excellent condition. No scratches, no peeling, no nothing. Approximately 10,000 miles on them. $450 (or trade) plus shipping, or local pickup. Center caps are included. Here are some pics...
  10. L

    Can straight piping cause running issues?

    On Thursday I took my truck to the muffler shop, had them cut off the cat and muffler and weld in a 3.5" pipe in it's place. Everything was fine on thursday. Friday I drove about 100 miles on a trip and just before I arrived I felt what I would describe as a "surge" on the freeway. (the truck...
  11. L

    Finally pulled the trigger...

    I just ordered a set of these wheels in 20X10. http://www.4wheelparts.com/PDT72156.aspx As you can see they come with a "star" center cap. In this pic: http://www.rizeind.com/05news_photos/photo_large12.html They are shown without the center cap. Is that what the hub will look like...
  12. L

    Help my truck rides like a tank!!!

    Ok that is probably a little far-fetched, but it really does ride bad. I drive a GMC 6500 and an International 4300 for work that weigh around 30,000 lbs when fully loaded, and these trucks ride much better than my F250! I picked up my buddy for work this morning and he got so pissed that he...
Back
Top