I recently acquired a new holland track skid steer that needed some work. It has an Iveco 336t in it. Looks like half a 12v cummins. Anyway i got it crank fairly easily but it has no power. WOT is just over 1500 rpm and if you push both sticks all the way forward it will stall out. I suspect...
These are about the only pics i could find. I tooks some of the dually at TS that had this kit, but i didnt take the time to figure out how they route the hot pipe.
Im trying to get some more power out of a FL70 with an ISC mated to an Allison. Its a 1994 model and i believe it is a 3060 allison. Plan to do some pump and afc mods, marine injectors, headbolt retorq and turbo upgrade. From what ive read the trans should hold around 450hp. Im sure the HX40...
this is the turbine map for a gt45. the 1.01 housing flows 37 lb/min at 2:1 pr
On this map for a gt42 the 1.25 housing flows 40 lbs per min at 2:1 pr
How do i read this?
Some kind of billet garrett with no tags on it.
Specs. Comp wheel: ~71mm/102mm Exh wheel: 94mm/84mm 1.28 AR wastegated housing.
iirc the gt4294 is 70.6/96 and 88/82
Any help? ill put some pics up in a minute
Buddy of mine was doin a burnout the other night and when he went to snatch 3rd gear his truck cut off. he messed with it most of the next day and eventually it started. the next night we were going to a friends place and after a wot 5th gear run the pedal went dead. pulled the injector lines...
Admittedly, im going a bit over my head on this but i like to learn by jumping in. I have spring break coming up and am planning on putting a large single i have laying around on my truck and using a m90 to make it driveable. I have a garret that i believe is a GT4202. It came off a 60 series...
As i design my supercharger/turbo setup came up with a need for a custom controller to make the supercharger clutch automatic based on driving conditions, rpm, tps, boost and exhaust brake. I have seen Arduinos used in other applications with success. A friend of mine has built and programmed...
Im am putting a roadranger ten speed in my truck and am trying to find a clutch. the trans has a 1.75" input shift and mounts to a SEA#2 bell housing with a 14" flywheel. It seems like im doing something that not a lot of people are doing so finding info on google is tough.
My truck is mostly a...