Search results

Looking for some opinions for a new cam. Running an 03 CR 2.5 puller I do have a 210/210 5k cast cam in it now and it's seems to work well but I'm rebuilding the motor here soon and debating to keep the same cam or change it up with some valve release pistons for a bigger cam. Thoughts...

So I'm having an issue with this kit I have on my 03 now. I have the old Style CP3 bracket and it broke at a pull the other day, so I ordered a new bracket. ATS went to a new style bracket so I figured well I'll need the new hard line that goes to the rail as well since the pump is mounted in a...

I'm in need of a oil filter housing for a 03 cummins thanks.

Alright guys I have a question and I'm just looking for everyone opinions on it. So back in the day we use to run 33/ 12.5 couser ct tires ya know when a super b charger and 100hp injectors you had somthing. So I was always told it was about the wheel speed that you needed to stay with the pack...

Try this again see if I can get any information. Needing another 10mm pump and wondering what the difference is between Exergy and Fleece pumps other than the price? Anyone have any idea.

I'm needing another 10mm pump and wondering what the difference is between Exergy & Fleece 6.7 10mm pump other than the price? Thanks!

I've been looking for a Eaton E-Locker and every place I've called said they are discontinued for a aam 9.25 anyone know anything about this? And where I could still find one?

Currently running a 03 CCSB CR running in 2.5 I'm needing some opinions on a gear setup. I'm running 4:10 now and only seeing about 3200rpm down the track or less depending on the track conditions. I have a new set of 4:56's sitting here but not sure witch way to go. My current setup is Flux...

Looking for a Good ecm and harness from an 06 CR truck also needing a gas pedal assembly from an 05 CR Thanks.

So it's an 03 ccsb, 47re swap for nv4500, 271-d tease, 4:10 gears, this truck had a 10:50 rear in it and I swapped it out for an 11:50 with 4:10's. So now that I have recently put this nv4500 in it everything seemed fine till the first pull. Had a little bounce at the start and the tcase was...

Ok guys I just finished up on my auto to Manuel swap with a nv4500 and a dual disc and 3rd gen heavy hydro's.. My pedal feels different from other trucks I've drove with a dd in it and also its making a horrible grinding noise when clutch is pushed in. It seems to go into gears just fine other...

I have a 03 CR that had a 47re in it and did a swap to a nv4500. Anyway I'm trying to figure out how to make the safty natural switch work to get it started.. everyone talks about a 3 pin plug but theres not one and only 2 plugs under the dash for the OD shut off 2 pin and the shift cable plug 2...

I have a 271-d tcase that I need to change the 23 spline input shaft out for a 29. Can I just buy a 29 spline input shaft an it'll replace it?

I'm looking for a full floater for a 11.5 aam.. Also a dual cp3 kit with out pumps let me know what ya got thanks.

Just wanted to say hello to all of ya