Search results

I've got an 06 I put a 6.7 in with all 5.9 electronics Running a 465 with Flux II injectors. EFI Tuning by Les problem is the truck is laggy down low and black smoke all the time. Doesn't matter what setting stock or race same smoke level. The higher tunes are much faster but it never cleans up...

Looking for a shop to do a rebuild on a blown up 2014 duramax. Text me 858-395-8289 Andy

WELL I INSTALLED AN EFI Tune in a 06 that was already running a smarty tune. I didn't know the truck had a smarty till further investigation because the EFI tune runs like crap! Could the Smarty be effecting the EFI tune? I have very bad smoke at lower rpms and the turbo response is crazy slow...

Putting an S467 in a 3rd Gen Stock location T4 foot down pipe is easy. Turbo to Intercooler I need 3.5 Piping with a 4" s drop. does anyone make this? I'm putting an order in to a mandrel pipe shop. Now the air filter connection looks like a total tight squeeze! Has anyone done this set up? 5"...

Does anyone on the west coast have an extra nut?? I lost one somewhere! Need it tomorrow! Overnight is fine if your in San Diego area call me! 858-395-8289 Andy

There must be ten plus models available on Ebay! I can't afford a new one!Which one would be best on 04 to current Dodge rams? I want to read Engine and trans and on the later models do the trans reset relearn. Any input really helps! If there is a better model from someone else please let me...

Just rebuilt an 06 new everything all Goerend parts including VB and TQ. Truck runs great only issue is an annoying quick down shift with the smallest pedal increase. So getting on the freeway give it pedal and downshifts 3000rpm hangs and then upshifts. Going to pass someone give it pedal and...

Has anyone done a 68rfe to aisin swap? What is needed to make this happen? They are becoming more available and hold up so much more!

having a trans issue I've seen before a couple of times. Pretty stock trans and motor has a smarty JR. With a heavy load going up a hill from a stop it will just rev but will not go forward. just a creep even in first manual just no forward motion! 4x4 lo and it will pull load forward. what is...

I've HEARD NOTHING BUT GOOD ABOUT THE AISIN TRANS. How hard is it to replace the crap box 68? Has anyone done this?

Are these available anywhere? need a set asap.

Got a truck in with a loud knock. I noticed all the adjustment screws were turned all the way in on the rockers. "BEYOND NORMAL" Pulled the motor did a quick tear down and noticed the cam had eaten about a 1/4" into the block on the rear. I pulled the cam and all the bearings were scored like it...

Looking to get a scanner to use on the rams from 04 to present. What functions are mandatory in a scanner? What scanner is everyone using? I was looking at this one from MAC Mentor Touch® Scout Scan Tablet with 10-PC. Cable Kit

Ok so I deleted the fuel filter on a 2012. The water in fuel light was on so I thought I could jump the sensor plug to make it go away. I turned the key on and something on the passenger side fried let out the smoke but I can't find it! the truck is now frying Alternators. Not even sure what's...

Anybody know what years changed the rear seal? I Figure the third gens are all the same. 07.5 to 12 6.7 same as 5.9.?! After that it gets confusing 13 to?

Got the motor in, Full delete everything is gone! New EFI Live tunes loaded and no start?! Cranks over fine just not firing Cracked lines has fuel at tubes. Checked everything several times and nothing Has new batteries and NO codes! Going to try either tomorrow! Any thoughts before I spray it??

I'm pulling the motor from a 2012 and have noticed the harness has no connector between the trans and engine?! IT IS ONE CRAZY HARNESS! has anyone removed the engine and what did you do for the harness? take apart at the ECM or? Also the smog crap is mixed into the trans wiring just to make it...

What's your experience with this cam in a 6.7? Any hint on your black Friday sale yet??

Fresh build start up normal test drive normal stop at light and check gauges light comes on Oil pressure at zero yikes. Shut off check fluids all ok start up head home all ok sit at idle bamm zero oil pressure! Put a real guage on it and when cold 25psi at idle when hot ZERO! TOUCH PEDAL AND...

I put a4th gen bed on my 3rd gen and was wondering if anyone ever figured out the lights? 06 has 3 bulbs and 4th has two so making turn signals work is being a pain! Any help would be appreciated!