Truck is a 97 F350 with a 12v Cummins in it I’m trying to get into the high 10s with it the truck has 3.55 gears An weighs bout 6000 pounds right now .which from what I found I’m gonna need to be close to 900 hp to get there this is what I have so far looking for some advise an some experience on what I should change an also add. Truck is a play toy not a Daily driver an I’m sure I forgot a few things
Engine
.20 over with Delipped pistons with wider bowls
Rest is factory
Ported polished head
Oringed
150 valve springs
Titanium an billet keepers an holders
Billet pushrods
Dual ram intake
Ats t4 manifold
Fluid damper
Camshaft is factory was looking at going with a 188/220 the head an block have been decked An that about the biggest for clearance will allow without getting fly cut pistons
Fuel
12mm pump benched flows around 550cc
.93 billet holders
4k springs thought about swapping to 5k springs ?
Afc live
5x22 industrial injectors not sure if these will get me there
.93 lines
Full cut delivery valves also have a set of 7mm delivery valves not sure which ones to run
Fass220
Dual fed pump
Adjustable timing gear running 25 degrees timming
Air currently have 67.5/83/1.0 Barder turbo thought about putting a 480/96/1.32 or a 488 over it not sure if that worth doing an using nitrous to help spool some or just selling An going to a different turbo setup
Trans
Firepunk comp 47re
Full manual valve body
Dpc 2500 stall converter
Nitrous
Nitrous express stacker 2 kit
Snow performance Water meth kit
Engine
.20 over with Delipped pistons with wider bowls
Rest is factory
Ported polished head
Oringed
150 valve springs
Titanium an billet keepers an holders
Billet pushrods
Dual ram intake
Ats t4 manifold
Fluid damper
Camshaft is factory was looking at going with a 188/220 the head an block have been decked An that about the biggest for clearance will allow without getting fly cut pistons
Fuel
12mm pump benched flows around 550cc
.93 billet holders
4k springs thought about swapping to 5k springs ?
Afc live
5x22 industrial injectors not sure if these will get me there
.93 lines
Full cut delivery valves also have a set of 7mm delivery valves not sure which ones to run
Fass220
Dual fed pump
Adjustable timing gear running 25 degrees timming
Air currently have 67.5/83/1.0 Barder turbo thought about putting a 480/96/1.32 or a 488 over it not sure if that worth doing an using nitrous to help spool some or just selling An going to a different turbo setup
Trans
Firepunk comp 47re
Full manual valve body
Dpc 2500 stall converter
Nitrous
Nitrous express stacker 2 kit
Snow performance Water meth kit