TBittner
New member
- Joined
- Mar 2, 2010
- Messages
- 462
Putting my truck up for sale as I don’t have the time I hoped to pull. Truck can very easily be street driven.
Truck is a 2004 sport 4x4 with nv5600 and currently has 49,xxx miles. I am the 3rd owner and have contact info for previous two owners if need be. Truck is very clean and has only seen snow a few times. Truck was also oiled under coated.
Current mods:
Southbend triple disk
ATS dual cp3 with arson kit
%230 percent over from Altered Diesel - believe I have flow sheets from exergy. Less than 1k miles on them
JEB 2.5 turbo for Full Pull Productions class
Turbo blanket
H11 head studs
4.88 gears still have the factory 3.73s
Front e-locker
Traction bars
Rear leafs are clamped
Roll pan with receiver and pulling hitch/sled stops (factory painted bumper included)
35” BFG KO’s on 4th gen 17s
Edge CTS 2 Pro
Flexalite Electric fans and water pump controlled by CTS
Has 5th wheel rails and spray in bed liner
Rear wheel well liners
Enterprise Engine Stage 2 head with springs and full port/polish and intake runner
Manson HD pushrods
Helix 2 Cam
7” stack
SRT Hood
HP Tuned by Gordon Lindamood
Driveshaft loops front and rear
Suspension stops
Fluidampnr
Front hanging weights
Full second gen swap with intake from source automotive
Marine Valve cover
Coolant Bypass
Weather tech floor mats
I am also including a good machined 6.7 block, good 6.7 crank, 12 valve rods and a good 5.9 CR crank, factory fan and water pump included.
$33k for it all. Call or text 724-454-2617
Truck is a 2004 sport 4x4 with nv5600 and currently has 49,xxx miles. I am the 3rd owner and have contact info for previous two owners if need be. Truck is very clean and has only seen snow a few times. Truck was also oiled under coated.
Current mods:
Southbend triple disk
ATS dual cp3 with arson kit
%230 percent over from Altered Diesel - believe I have flow sheets from exergy. Less than 1k miles on them
JEB 2.5 turbo for Full Pull Productions class
Turbo blanket
H11 head studs
4.88 gears still have the factory 3.73s
Front e-locker
Traction bars
Rear leafs are clamped
Roll pan with receiver and pulling hitch/sled stops (factory painted bumper included)
35” BFG KO’s on 4th gen 17s
Edge CTS 2 Pro
Flexalite Electric fans and water pump controlled by CTS
Has 5th wheel rails and spray in bed liner
Rear wheel well liners
Enterprise Engine Stage 2 head with springs and full port/polish and intake runner
Manson HD pushrods
Helix 2 Cam
7” stack
SRT Hood
HP Tuned by Gordon Lindamood
Driveshaft loops front and rear
Suspension stops
Fluidampnr
Front hanging weights
Full second gen swap with intake from source automotive
Marine Valve cover
Coolant Bypass
Weather tech floor mats
I am also including a good machined 6.7 block, good 6.7 crank, 12 valve rods and a good 5.9 CR crank, factory fan and water pump included.
$33k for it all. Call or text 724-454-2617
