dipapadakis
New member
- Joined
- Jan 20, 2011
- Messages
- 151
So today i pulled my buddys ats tranny out of his truck (4wd) 47re and I replaced the pump/convertor seal, pump gasket, and the pump o ring. We didnt check the endplay before but after replacing the pump it has about 1/4 inch of endplay, the front drum did pop out of the rear drum slightly, but I got it back in and fully seated. (tabs on the front drum are just below flush in the slots on the rear drum) the plastic washer that rides between pump and front drum is in, there no noticeable wear on the plastic washer. Not sure what could be causing this much endplay, any ideas???