47re squeal

[mclunas]

98 12v, replaced TC with a DTT put it all together and no leaks when first started, took for a spin and at low R's the throttle is hard to push, mid R's fine on throttle pressure, 1/4 throttle everything shifts fine, half still shifts fine but sqeals like there is to much pressure, 3/4 gets louder and squeals from 1200 R's up and now it leaks at input seal dunno if this has anything to do with it if i leave it in first and take it up to 2300 and let off the r's come down slowly like they should, everthing works fine but the throttle stiffness and squeal WTH could it be

 

[Stangpwr71]

You used dtt parts. If i had it to do over again i definatley would not have.

 

[cumminspower88]

did u mess witht he tv cable at all? they can be really tricky to get set.

 

[mclunas]

i took apart the valve body and cleaned it everything looked fine, a little dirty on the screen but not bad, there is no more pressure on the throttle cable but it steal squeals when i give it a some juice, doesnt squeal when i stay at a constant speed or slowly speed up, i am leaking out the input seal a steady drip almost small stream, don't want to change the seal till i figure out what it is*bdh*