B BigDamnCummins New member Joined Jan 31, 2010 Messages 110 Feb 11, 2010 #1 I am putting together a 6.7l bottom end, and i was just going to run my 5.9 common rail ecm. Will this work?
I am putting together a 6.7l bottom end, and i was just going to run my 5.9 common rail ecm. Will this work?
outlaw99 New member Joined May 20, 2008 Messages 4,209 Feb 12, 2010 #2 I wouldn't see why not. just use your 5.9 sensors on the bottem end.
B BigDamnCummins New member Joined Jan 31, 2010 Messages 110 Feb 12, 2010 #3 ok, i just wasnt sure if the longer stroke would throw off the timing at all?
morkable Just Over Broke Joined Jan 30, 2008 Messages 5,956 Feb 12, 2010 #4 I am running a 6.7 with 5.9 electronics.. I have a 5.9 head and injectors no problem
B BigDamnCummins New member Joined Jan 31, 2010 Messages 110 Feb 13, 2010 #5 once you put the 6.7 bottom end in your truck, were you able to run bigger injectors?
B BigDamnCummins New member Joined Jan 31, 2010 Messages 110 Feb 13, 2010 #6 Can i tap and plug the steam holes in the surface of the block? I was going to fill the head with concrete, and dont want those steam holes to blow out the hg since they are going to be dead headed.
Can i tap and plug the steam holes in the surface of the block? I was going to fill the head with concrete, and dont want those steam holes to blow out the hg since they are going to be dead headed.