is the step down avialable yet also does that have warrenty
I can't keep steady strong pressure with mine at all! I have been running it for 2 months now......sometimes it holds and most of the time it don't.
I have pulled all the fittings and resealed them and tightened the hech out of them...I am pretty positive I don't have an air leak. I have pulled the gear cover off and there is no scarring in the housing or rotor? It holds steady when it is cold but once I get to op. temp for awhile it will start to build and bounce again. It drops to 15 and slowly build up to around 18 then does it again or stays steady then starts or start bouncing all over the place without dropping past 15 lbs??
All electrical connections are good and have a new set of batts and get proper volts to the plug.........you have any help for me??
Thanks!!
Check to another gauge would be my first suggestion. Just to ensure were not pulling our hair out for no reason. Then I would like to get you a different spring. Or the other way around. Call in here to the office and I can get you one on the way. Sorry for my delay on checking this.
I'm having the same issue as TheNatural31, but my cruising psi fluctuates between 15 and 12. I'm running a second 2-micron filter underneath my intake horn, so that's probably why it's slightly lower than his. Under WOT runs, I can get the psi to drop as low as 4psi...this is what worries me.
Did the different spring work for TheNatural31? I will call in tomorrow and figure out what you'd like to do. Is there someone specific I should ask for?
I know for sure I don't have any leaks in my system! And I'm sure it's not the guage, because I previously had a Walbro setup and it would ALWAYS show consistent psi numbers. Never messed with the guage when I put in the AirDog, just cut into the 1/2" line and installed the new pump.
Any info/help would be greatly appreciated!
Jared
i have an AD 150 for a 97 cummins but i'd like some guidance.. it didn't come w/ directions.. my biggest concern is the 1/2" dip tube i've heard some people having problems and rigging there own way onto it... mainly i j/ need directions... if you could e-mail me some... tater_thrower76@yahoo.com