Boostediesel
Boost Addict
- Joined
- Oct 6, 2009
- Messages
- 575
Banks Intercooler with boost tubes $800
built 03 short block with 06 cylinder head. engine was built by Mike Coveks at Total Engine Concepts in West Palm Beach,FL. engine is still at his machine shop. block was hot tanked, and magnafuxed. block was decked, bored .40 over with a torque plate, align honed and 5 hones on the finish. new QSB 480HP pistons with Cummins rings and wristpins. 12 valve connecting rods, shotpenned with A-1 heavy duty rod bolts. Piston to wall clearance opened up accordingly. New Cummins bearings, including main, connecting rod and cam bearings. New Cummins oil pump with Cummins lower gasket set. New Cummins main bolts. stock crank has oil holes chamfered. entire rotating assembly was balanced. New F1 Helix 2 Cam installed, all freeze plugs staked in block, all bolt holes bottom tapped for use of studs. SFI flex plate for a 47/48 RE trans. also have an 06 complete cylinder head, brand new head bought but never used. preffer to sell engine and cylinder head together but can sell seperatley.engine will come with all build specs and build sheet. engine with cylinder head $6600. engine without cylinder head $5600.
06 cylinder head,new, complete $1200
FASS 150, always ran Fleetguard 2 mic fuel filter, and Fleetguard 10 mic water separator,comes with brackets and if needed can supply wiring harness runs perfectly. just the pump, no filters $300
DiabloSport Trinity, near new in box $400
DiabloSport Extreme Power Puck new, never put on truck, for 2003-2004 $225
DiabloSport Power Puck, used, works great, 2003-2004 $70
6.7 Fuel Rail, injector lines, injection pump feed line, shimmed $85
2 5.9 fuel rails, have some of the lines and sensors $50 each
2 sets of 5.9 crossover tubes, great shape, $50 per set of 6
RBP 5 inch stainless steel down pipe $85
2003 stock cam, great shape $40
47RE stock flexplate $30
need this stuff gone, gotta pay for school, call me for any questions 772-341-2948 Dave, thanks
built 03 short block with 06 cylinder head. engine was built by Mike Coveks at Total Engine Concepts in West Palm Beach,FL. engine is still at his machine shop. block was hot tanked, and magnafuxed. block was decked, bored .40 over with a torque plate, align honed and 5 hones on the finish. new QSB 480HP pistons with Cummins rings and wristpins. 12 valve connecting rods, shotpenned with A-1 heavy duty rod bolts. Piston to wall clearance opened up accordingly. New Cummins bearings, including main, connecting rod and cam bearings. New Cummins oil pump with Cummins lower gasket set. New Cummins main bolts. stock crank has oil holes chamfered. entire rotating assembly was balanced. New F1 Helix 2 Cam installed, all freeze plugs staked in block, all bolt holes bottom tapped for use of studs. SFI flex plate for a 47/48 RE trans. also have an 06 complete cylinder head, brand new head bought but never used. preffer to sell engine and cylinder head together but can sell seperatley.engine will come with all build specs and build sheet. engine with cylinder head $6600. engine without cylinder head $5600.
06 cylinder head,new, complete $1200
FASS 150, always ran Fleetguard 2 mic fuel filter, and Fleetguard 10 mic water separator,comes with brackets and if needed can supply wiring harness runs perfectly. just the pump, no filters $300
DiabloSport Trinity, near new in box $400
DiabloSport Extreme Power Puck new, never put on truck, for 2003-2004 $225
DiabloSport Power Puck, used, works great, 2003-2004 $70
6.7 Fuel Rail, injector lines, injection pump feed line, shimmed $85
2 5.9 fuel rails, have some of the lines and sensors $50 each
2 sets of 5.9 crossover tubes, great shape, $50 per set of 6
RBP 5 inch stainless steel down pipe $85
2003 stock cam, great shape $40
47RE stock flexplate $30
need this stuff gone, gotta pay for school, call me for any questions 772-341-2948 Dave, thanks
Last edited:
