turboman1
New member
- Joined
- Aug 20, 2008
- Messages
- 248
I pulled the front axle shafts out to inspect them but there is a lot of dirt in axle tubes just before the seal, which looks like it is where they press the tubes into the carrier. Does anybody have a good method they have used to clean the tubes out so when I put the shafts back in i do not get dirt on the splines?
Also is their supposed to be a seal on the very end of the tube where the shaft exits it?
Thanks
Adam
Also is their supposed to be a seal on the very end of the tube where the shaft exits it?
Thanks
Adam