clutch parts, need another brain

[bosshogg]

Ok I am swapping an nv4500 behind my 4bt. trans has the 1-3/8" input shaft, and I have my old 13" 6spd flywheel bolted to the engine. I have a stock 6spd clutch and pressure plate as well for it. My question is what release arm and throw out bearing do I need to make it work? Will a stock nv4500 release arm clear the big input with a stock 6spd throw out bearing? Do I need a 6spd release arm? Hopefully someone out there knows more than I do at this point, I only want to put this thing together once...

 

[Valair1]

same fork for nv4500,nv5600 and g56 should have 52087515 stamped on it and that side goes towards pivot ball. So you should be fine.

 

[full pull]

They all use the same bearing also.

 

[cummin get it]

I got a couple spares laying around if you need one just pay the shipping

 

[bosshogg]

Thanks for the help, gonna make sure I have the factory arm, it could be aftermarket. May take you up on that offer cummin get it