daithi2
Nevermore
- Joined
- Aug 8, 2008
- Messages
- 607
hey guys, couple months back i got a full billet 47rh setup from yall. i just finally got the chance to start stabbing it. my problem is the converter does not sit inside the bellhousing, it stick out past about an inch. it is on both sets of splines and when i set the converter inside the flexplate on the motor its about an inch from being able to put the bell housing bolts in.
i pulled the converter off and re-stabed it on the splines several times and it is goin on both sets fine. i pretty sure it wont go further because the converter is only 1/4" from bottoming out on the bellhousing when its on the tranny.
what am i missing? the converter is going all the way on the shafts, the converter seats fully inside the felxplate but im still an inch from being against the motor.
heres the converter yall sent me.
i pulled the converter off and re-stabed it on the splines several times and it is goin on both sets fine. i pretty sure it wont go further because the converter is only 1/4" from bottoming out on the bellhousing when its on the tranny.
what am i missing? the converter is going all the way on the shafts, the converter seats fully inside the felxplate but im still an inch from being against the motor.
heres the converter yall sent me.