Installing front and rear seals can be a pain sometimes if the housing isn't aligned perfect. We had these made for the shop. I was thinking of having a run of these made. Any engine builders have interest in needing a set?
We just talked about these in a thread a while back. I got one from Quad 4x4. It's so awesome to drive the huge rear main seal in 30 seconds and know it's square. Quad's installer is expensive, but it's stepped on the inside so it will work with speedy sleeves
Seems like there is quite a bit of interest. I'll get with the machinist and report back. I'm not looking to make money on these. They are quite pricey already.