Dana 80/60 gears

bigsexy7.3

New member
Joined
Feb 17, 2013
Messages
201
So im getting.ready to go with 5.63/4.56 or just 4.88s but what all will be needed if I have 4.10s already. What would guys recommend for gears? Im confused on the limit of the carriers
 
Is it a stick truck? I always heard if you have 33in tires go with 4.88's. If you have 35's go with 5.13's and low lock and launch in 4th. And someone correct me if I'm wrong but I'm sure you will need a new carrier for the rear if it's anything above a 4.10 ring gear. Any gear below 4.10 you can use the same carrier. And you can just use a spacer on the Dana 60 if you were trying to do it on the cheap and bolt your new gear on to the spacer.
 
Im looking at spooling the rear and welding for front for now. Where do you get the spacer from?
 
Im looking at spooling the rear and welding for front for now. Where do you get the spacer from?

I got mine from (ptpullingchassis). He is a member on here and he was a good guy to deal with, are you going to upgrade axel shafts when you buy the spool?

On edit. I think I got the spacer from him? Lol it was a few years back and he either told me where to buy it or sold it to me. He sells all sorts of parts, that's where my spool and axels both came from.
 
Last edited:
No the spool for.the rear is put of my buddys truck and its for stock spline axles
 
Back
Top