DIY intercooler piping

[cummin get it]

I've seen the link floating around here before but can't remember what the website was called. So if someone knows where I can buy reasonably priced 3" tubing, v band clamps, and flanges; that would be great

 

[Headcase98002]

Steel or aluminum or aluminized steel? I use Columbia River Mandrel Bends, Summit Racing and eBay. As for V-bands I use Himni-Racing.

 

[97crewcab]

Mandrel-bends.com or ebay

 

[cummin get it]

How about a 5 1/2 silicon boot that reduces down to 5"? I ended up getting the aluminum universal large kit from frozen boost I think that kit was well priced for what was involved. I can't find silicone boots bigger then 5" though.

 

[cummin get it]

Also need a 6" to 5" boot.

 

[Todd W]

racepartsolutions has a lot of mandrel bends and oringed vbands. I have got a lot of stuff from them. also intakehoses.com has rubber boots if you are just using them for an air filter and they won't be under boost then a 6-5 inch is pretty easy to do.

something like this perhaps?

http://intakehoses.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=6H5&Category_Code=RHH8

 

[Todd W]

How about a 5 1/2 silicon boot that reduces down to 5"? I ended up getting the aluminum universal large kit from frozen boost I think that kit was well priced for what was involved. I can't find silicone boots bigger then 5" though.

Here you go.

http://intakehoses.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=R40B-500-550&Category_Code=RSS1

 

[cummin get it]

Yes that's exactly what I needed thank you Todd.

 

[cummin get it]

And yes it's to go from turbo inlet to air cutout and from air filter to air cutout.

 

[TheSilverBullet]

And yes it's to go from turbo inlet to air cutout and from air filter to air cutout.

I run that same 5.5 boot on my air intake for my twin setup. It's very good quality and I'm glad because it was the only one I found:rockwoot: