Driveshaft loop?

[r-n-r]

I have spoken with a few people but have not moved on anything yet. Just wondering what people are doing for their loop. And, does anybody know if a straight bar across the frame will fit under the shaft?

 

[joefarmer]

The one's I've seen go across the top of the rails and "U" under the drive shaft. It looks pretty slick.

brandon.

 

[UNBROKEN]

Very easy to fab up too..a little flat bar and a few bolts and you're good to go.

 

[joefarmer]

I hacked up one of these for the front driveshaft after advice from other racers:
http://www.jegs.com/webapp/wcs/stores/servlet/category2_10001_10002_13103_-1

Here's the patterns for the rear shaft:
http://www.jegs.com/webapp/wcs/stores/servlet/category_10001_10002_10061_-1_10057

brandon.

 

[turbothom]

Just in front of the tank, there is a 3 inch spot that will allow for a straight shot under the frame. Then loop over the shaft. That's what I do.

On the rear, up top is the only way.

 

[IC-Smoke]

will the "flat spot" be true on a STD cab Long bed and a Extended cab Long bed?

Thanks
Ian