EFILive Public Release Software - June 2014

[EFI Support]

EFILive is pleased to announce Public Release software, dated June 21, 2014 is now available.

This release contains updates to V8 Scan and Tune and V7 software, along with firmware and boot block updates. All customers should update to the below versions:

V8 Software: V8.2.2, Build 253
FlashScan/AutoCal Firmware: V2.07.62 (Jun 21, 2014)
FlashScan/AutoCal Boot Block: V2.07.07 (Feb 07, 2014)
V7.5 Software: V7.5.7, Build 260

This public release commits many controller and functionality enhancements including 2015 LML tuning and A50 reading and flashing. Software and A full list of changes can be found here. EFILive - The Latest - Software Release - Jun 21, 2014

Cheers
Cindy



Sent from my iPad using Tapatalk

 

[Tristan]

Any plans for support for cummins isf 2.8/3.8 motors? Specifically a Foton Tunland . Absolutely zero aftermarket support for them right now

 

[EFI Support]

Do they actually sell any? They have been in Australia for 12 months and I'm yet to see one. The opening sentence from an Australian national newspaper review reads......

Quality and safety concerns leave lukewarm newcomer Foton in no man’s land in the competitive dual cab ute segment.

The article goes on to say that they needed a replacement vehicle to complete the review, and the only good thing the vehicle had going for it was it had a Cummins badge on the side.......

I don't see there being a market for Chinese vehicles in either the USA or Australia in the near future.

Cheers
Cindy

 

[Tristan]

Yeah I agree the quality is suspect but it really is not that bad, I'm in Australia and there are a few around. Since initial testing they have improved safety by adding stability control and significantly improved corrosion resistance to suit Australian conditions. I don't care much for the car but the 3.8 is a perfect engine swap for landcruisers and patrols in my opinion