WAYNES WORLD
New member
- Joined
- Dec 28, 2006
- Messages
- 413
IMO, that should have been bored, rather than just "cleaned up".
The "eyebrow" is the result of trying to offset hone out the deepest wear, hoping you'll catch the shallowest side while doing it.
Machinists try this on V-8s a lot, with similar results.
Mark.
Well they're response is kind of bs, but they're not completely wrong. I assume they just ran a hone in your block. The only way to make it go away is to bore to .020. It's nothing that they did incorrectly.
Hitting them with a berry hone after rigid honing is time well spent to eliminate questions.