one time my buddy measured out a 300' burnout from them..LOL
ya hard to spin, until you got them spinning.. lol one time my buddy measured out a 300' burnout from them..LOL
also pulled a 1.67 sixty foot time that night..
but seriously your truck look good mike..
And you dont really even care cause they are like $400 a set
Toyo proxy ST 305/50r20. Talk to Lostnwalmart, he found a store where they're 600 shipped I think. I payed 650.
I also use them to jack up the truck, so I can keep the axles clear LOL
I completely removed the stock 4" blocks. All I have now is
stock leaf pack with stock helper spring
a 2.5in lift shackle flip
and 1" zero rate block used for centering the axle with the shackle flip
its now at 1" below stock height. I'm going to pull both the zero block and helper springs I think, for another 1.5" drop. I'm going for a full 2/4ish drop.
Thanks!
Sweet! Looks much better now man. Now get rid of those running board things, the tool box, the mud flaps,...........the flapper stackLOL (which I just noticed for the first time), and get a front bumper that isn't missing pieces and it would be looking really good!.
Seriously, the truck looks good Mike. Clean her off a bit and take some pics of her outside.
Mike that's the same size tire I'm running, but I have the ST II.
The new 67/83 will hopefully be on this weekend too!
Mike that's the same size tire I'm running, but I have the ST II.
You gonna start calling her Panti Droppa now?
Looks good Mike, better a little lower...still think you should have went with all terrains. LOL
Can you take that retarded extra rear bumper off now?
Epically posted via Tapatalk...
Is this turbo a BW s400? Is it the same 67.7mm compressor? If so curious to know what you think when you get it on!
Looks good Mike.
so basically what every one is trying to say is its less ugly now LOL
You gonna start calling her Panti Droppa now?
Dave, did you drop yours in the front? I can't remember.
Mike, I would take a good look at the compressed spring pack when you take the helper out. It only drops maybe a 1/2" and removing it made my springs crown at the block contact point. I put the helper back in and milled 13/16" off the top and bottom of the block. Works and looks perfect now.
Purple Panty Droppa
Epically posted via Tapatalk...
Dave, did you drop yours in the front? I can't remember.
Mike, I would take a good look at the compressed spring pack when you take the helper out. It only drops maybe a 1/2" and removing it made my springs crown at the block contact point. I put the helper back in and milled 13/16" off the top and bottom of the block. Works and looks perfect now.