heres a different question

If it is the same sensor as on a CR it is a metric O-ring boss fitting. It will fit without leaking in a 6an o-ring boss fitting. see if you can thread a 6an flare adaptor into the port to it's shoulder. if you can the fittings you need can be found at a hydraulic fitting supplier.
 
Signal 73 said:
:thankyou2: for the informative post sinner.
Click to expand...
PS it is 14X1.5 could only find a 3/4pipe bushing with the wrong female thread so drilled it out and tapped it that part of the project is done.
 
Yeah i was fooling around with mine on an old block a 3/4 NPT plug fit into the 12v temp hole and the 24v one is a 1/4 NPT i believe.
 
You must log in or register to reply here.
Back
Top