farmerjoe27
New member
- Joined
- Sep 23, 2009
- Messages
- 1
Hey what are the best ways to fix up a 1990 cummins 4 wheel drive
Intake, exhaust, DennyT fuel pin, DDP4 or POD injectors. Turn the full fuel screw on the back of the pump a few turns while the engine is off, then start it up. Have a board handy in case it runs away so you can cover the turbo to shut it off. You'll have to adjust the idle way down. Keep turning up the fuel screw more and more until the truck sort of "hangs" when you rev it up. Turn it down a bit from there and have at it. Oh, and install a fuel system or at least an electric lift pump. Should be about 270-300 rwhp with those mods.
all that stuff + 3200 GSK, cranked AFC, BHAF, water/meth injection(optional), and dont forget a good clutch if its a 5spd
is JQmile the guy from diesel power with the project rustbucket truck?
yeah that waht i though....he is obviously dooing somting wron with that truck ...oldcool90 on 1stgen.org is making 350hp with a non ic truck with no nitrous and stock injectors....hes dooing somthing wrong aftermarket sticks to olny be making around 300