Icp issues?

K

krazyk

New member
Joined
Nov 24, 2011
Messages
1
Hey I replaced my ICP sensor and the pigtail and I did a water pump and fuel and oil filters when I buttoned her up so start but idled rough I just figured it was working the air out of the fuel system so after about 15 mins I tried to drive it and I didn't have any throttle response and just poured out black smoke so I **** her down and haven't been able to start her since I might have made a rookie mistake since all the wires were the same color and same size I just got and spliced I hope that's not the case because I have no clue on which way they go any advice would be much appreciated
 
You can unplug the ICP. It will still start up. It will just default the pcm to 100% or so
 
You must log in or register to reply here.
Back
Top