Injection lines

S

SuperiorRam

New member
Joined
Dec 5, 2008
Messages
1,239
I'm trying to find the six injection lines to convert my water to air aftercooled rotary engine to a p7100.

I found a picture of a engine with that setup so it's out there somewhere the serial number is 69734587 but the guy I talked to at n power said its not a p but rather a denso pump and couldn't tell me that the lines will match up to a p7100?

The line part numbers are
1. 3926450
2. 3926451
3. 3926452
4. 3926453
5. 3926454
6. 3926455

It may be easier to just find a 5.9 with the water to air and a p-pump for the correct part numbers but I would think that these would work but I know your the best so...
 
I don't believe those lines will work on the p-pump. Let me do some digging.
 
SuperiorRam said:
Thank you very much!
Click to expand...


Your injectors may be an issue if we can find the lines. Measure the nut on the injector end of the high pressure line. I bet the are the smaller one. (12mm thread)
 
Those numbers lead me to a P3000 pump? Not sure the lines are the same.
 
Snedge said:
Those numbers lead me to a P3000 pump? Not sure the lines are the same.
Click to expand...

They are for a 3000, but they work. Not sure what the difference actually is.

Here they are attached to a 913 pump off a Dodge.

SpeelmanIntake_zpse2121d7f.jpg
[/URL]
 
Jeff could you pm me a quote for the lines I have a return and lots of hold downs shipping will be to 55792
Thanks again
 
You must log in or register to reply here.
Back
Top