Injector solenoids

[wannabecummins]

So today I go to put my injectors in after getting them tested. Two of mine have bad delivery and return rates. So a friend has two good(tested) used ones. We get them all installed, get the connector tubes in. All the lines. Start putting in the solenoid wires and we notice that ine solenoid is not in the same plane as te others(studs and brace on top) pull the injector thinking we got it wrong an ****ed it up. It's all good. Turns out te solenoid top is twisted 90, in relation to the connector tube seat. What do I do? Is this fixable? Or is the injector pooched?

 

[TCDiesel]

No.... you can just clock the solenoids to the correct position so the wires can attach, you will be good to go.

 

[wannabecummins]

Is there a special tool to loosen the collar that holds the solenoid down? Or will just a standard wrench work? If so what's the procedure to clock the solenoid?