Intercooler pipe flex joint

chadc

New member
Joined
Nov 24, 2010
Messages
163
V banding my intercooler pipes what is everybody using as a flex pipe or bellow mid pipe? 3in

Sent from my SM-N920V using Tapatalk
 
Kronk on here uses the Vibrant Vanden clamps on his twins and if I could weld, I'd rig those up.
 
Almost all I ever see are made for exhaust. Will they hold up to 80+ psi?

Sent from my SM-N920V using Tapatalk
 
Ace race 304 bellows is what I'm using in my setups. and seem to be holding up fine. I havent pushed them past 70psi but dont see an issue with 80+
 
Possible to eliminate boots all together by running bellows on both pipes and v banding everything?

Sent from my SM-N920V using Tapatalk
 
Possible to eliminate boots all together by running bellows on both pipes and v banding everything?

Sent from my SM-N920V using Tapatalk


Theoretically yes I don't see why you couldn't but it would get expensive real quick


Sent from my iPhone using Tapatalk
 
Most people seem to say leave one boot somewhere. I'm thinking if you wanted 100% vband you'd want 2 bellows to take up the slack unless you've got aftermarket engine mounts to control it more.
 
Most people seem to say leave one boot somewhere. I'm thinking if you wanted 100% vband you'd want 2 bellows to take up the slack unless you've got aftermarket engine mounts to control it more.

Yeah that's also what Johnny at Stainless said regarding harmonious vibrations that the twin piping gets exposed too.
 
Probably v band intake and compressor outlet and run boots on the intercooler.

Sent from my SM-N920V using Tapatalk
 
Last edited:
If you want zero boots, get some VanJen clamps as already mentioned. They have a good amount of angular and offset misalignment, and have about 1/4" axial movement if I remember right. They aren't cheap, but neither are v-bands. And you can eliminate all the v-bands by using the VanJens. And they can be easier to assemble than v-bands if there is any pipe strain in your system.
 
If you want zero boots, get some VanJen clamps as already mentioned. They have a good amount of angular and offset misalignment, and have about 1/4" axial movement if I remember right. They aren't cheap, but neither are v-bands. And you can eliminate all the v-bands by using the VanJens. And they can be easier to assemble than v-bands if there is any pipe strain in your system.

The vanjens aren't as great as they are made out to be, at least the vibrant ones. They are supposedly rated to 120 psi but i've blown up 5 of them at 100ish psi. The pressure blows the end out of the clamp, so I had some steel ones made up and haven't had a problem with them yet.
 
Depends on the size of them. The bigger the joint, the less they are rated for. IIRC, on Torrey's truck they had an issue with the pins in the clamps bending, but nothing failing. That was on a single charger around 80 psi.
 
Back
Top