More puller part out.

Johndeere9610

Johndeere9610

Ford guy
Joined
Jun 2, 2007
Messages
629
24v main studs used 3 times $150
Factory 24v block stiffner $75
P pump case and cover with stock gear $500
Vac pump $50
Nv4500 stock input $750
Nv4500 big input $1250
241 dhd t case $500
Dana 80 with billet spool and 38spline axles 4.88 gears amd 1480 yoke. $2500
13mm pump with warp drive gov. $3000
1 peice Alum drive shaft with soild 1480 joints and slip yoke $550
Sb 3850 dd needs rebuilt $250
Factory dodge hitch reenforced $100

thanks for looking
Rusty
 
do you know how much rebuilds run i have a buddy thats been looking for a dual disc
 
pump info

13mm p7100 Just had it rebuilt in june by joliff diesel from elnora Indiana it was built by CDS and came off brandon millers black S-10
have flow sheet to go with
It has a warp drive auto gov on it. Witch makes it fuel like a ag cover
max is 800cc have over 4600 invested in it.
The warp drive lets it run like a stock pump up to about 2800rpm then after it that it takes off and just keep fueling its basicly unlimited rpm
It has a 215 quick rate cam in it.
 
I think a rebuild runs around $900 from South Bend. That is a rough number though because I am sure it all depends on what needs replaced.
 
Cummins_Diesel_ said:
How about P-Pump to 24v lines?
Click to expand...

Still have them $300
They are .120 stainless steel

Also
A-1 rod bolts $100
Older haisley sled puller cam needs cleaned up a little $250
Stock 24v cam 200
Stock crank was blanced with the rods needs new tone ring $150
24v motor mounts $50
Engine to bell housing plate $50
Stock front drive shaft $150
Dana 60 front lincoln locker with posi loc 4.88 gears $1000
 
Last edited:
It was in my engine when I got it and it had 120 fly cuts so I guess it does. It also come with bolt on gear.
 
txt pics of the ds and the hitch to 330-268-9451. thank you. ds is for an ext cab long bed rite???
 
Pm sent, dibs on rod bolts and motor mounts if still available.
 
Last edited:
You must log in or register to reply here.
Back
Top