Need drive shaft measurements

[CTD01]

I am doing a 5 speed swap on my 01 extended cab shortbed. It will have a nv4500 trans 241 dhd and dana 80 rear. Can some one give me at least the measurement for the rear shaft so I can have it made up and all ready for installation. Id like a measurement of just the shaft not the yoke. Thanks Paul.

 

[Signal 73]

paul im pretty darn sure its the same length as the driveshaft for the auto/70 axle, the difference in the axle and trans lengths make up for it. the front driveshaft is longer however.

 

[CTD01]

k good to know