New valve cover

[ISBeINSIDE]

Built myself a new valve cover/ breather setup... still a bit raw, but that's the basic design.

Sent from my SAMSUNG-SGH-I717 using Tapatalk 2

 

[HeTheAethyr!]

Looks good... Gaining needed real-estate for future intake moods I would assume?

Also, the brass fittings are for block breather tubes?

 

[ISBeINSIDE]

yes they are breathers 1/2npt was thinking about making it cleaner with AN fittings. was thinking of putting my A2W intercooler over the engine...

 

[lenahan05]

not sure, but i would think your going to want to add a splash cap on the inside of the cover so it doesnt puke oil out the tube. just a thought.

 

[DEZLFREK]

looking good

 

[ISBeINSIDE]

not sure, but i would think your going to want to add a splash cap on the inside of the cover so it doesnt puke oil out the tube. just a thought.

under where the breather tubes are welded is not open to the valvetrain area directly. hoping it acts as its own baffling.

 

[ISBeINSIDE]

Sent from my SAMSUNG-SGH-I717 using Tapatalk 2

 

[ISBeINSIDE]

thank you adam...

 

[ISBeINSIDE]

Installed...

Sent from my SAMSUNG-SGH-I717 using Tapatalk 2