dummins
Another moron
- Joined
- Jan 9, 2012
- Messages
- 262
I have a 1998 qcsb with a sb3600 and I recently was messing around and hot rodding it against a buddies deleted 6.7 and after that I couldn't get it to go into gear. So I did the upgraded hydraulics from south bend to complement the clutch and after doing so it still has the same issue. So my concern is I bent the fork and it's not allowing the throw out bearing to fully push on the clutch. Is this a common problem or am I just that lucky.
Truck when started in gear and releasing the clutch will move and doesn't lurch but if started in nuetral and try to push the clutch in and put in gear it will lurch. Any ideas before I tear it apart would be appreciated.
Truck when started in gear and releasing the clutch will move and doesn't lurch but if started in nuetral and try to push the clutch in and put in gear it will lurch. Any ideas before I tear it apart would be appreciated.