Oil Drain for twins

[Ether Man]

ok guys, i have a motor on a stand that i am putting a gasket kit in and i was wanting to weld a bung in the oil pan while it was out in case i ever go to twins. can anyone tell me where a good place to get a bung is that i could put a cap on for now or plug. just throwing around some ideas in my head. thanks. this is on a 96 block that doesn't have the plug to knock out in the block.

 

[DieselTweaker]

Steel AN fitting tig into the pan works well.

Zach

 

[9 LIVES]

http://www.turbofittings.com/miva/merchant.mvc?Screen=PROD&Store_Code=T&Product_Code=40-300-003&Category_Code=M

Teflon tape & a plug should fit in there just fine.

 

[Muddin_dude06]

Get a 1" NPT or 3/4" NPT steel pipe fitting from a hardware store, then just put a plug in it.

 

[mondtster]

Get a 1" NPT or 3/4" NPT steel pipe fitting from a hardware store, then just put a plug in it.

This is what I would do.

Summit also sells pipe fitting weld in bungs too.

 

[Jim Fulmer]

Another good place RacePartSolutions - Fast Parts At Discount Prices

Jim