Questions on settin up Engineered Diesel's WG and spacer plate setup

O

oldsmokey97

New member
Joined
Aug 5, 2006
Messages
744
Just install but i have some questions on plumbing the valve itself...

Correct me if I am wrong but you plumb regulated boost to the top side and drive pressure to the bottom .... correct.

What do you set the regulator at on the boost side. I just need a starting point.



Lance
 
Start with 20 psi if you have both of the stiff springs in the gate.
 
well..... got is somewhat setup but my engine locked up today. Pulled the front cover and everything is fine up there so it is something in the bottom end. So.. it will be a while before i will be worried about the WG again.

Lance
 
ya well.. it unfortunate because there is a dyno not this weekend but the next (April 4 & 5) that i have been waiting on for about....... well... since last year. I WAS hoping to put it on the rollers since the 80mm instead of 75mm on bottom, cam, and intercooler along with a little more fuel and the new WG along with a good HEALTHY shot of spray. But looks like thats not happening this year.
Oh well.

ALL I HAVE TO SAY TO ALL OF YALL FROM TEXAS IS LOOK OUT NEXT YEAR CUZ (from Tombstone) HHEELLLL'S COMING WITH ME YOU HEAR....... HHHEEELLLLLLS COMIN WITH ME!!!!!!!!!!!!!!!!!!!!!!!!
LOL
Lance
 
You must log in or register to reply here.
Back
Top