Rods

BigYellowIron

BigYellowIron

Diesel Tech
Joined
Aug 22, 2007
Messages
1,400
I have 2 sets of rods, one from a 95 12v and a set from a 2000 med duty truck 24v engine. Which ones would be better to put in a pulling engine.

I think the 12v ones have USA on them and the 24v ones have Mexico on them.

Any Ideas?

I'm wanting to get rid of a set of them so I want to know which ones to keep.

Thanks
Adam
 
im not 100% but i think the mexicos are lighter than the brazils but not sure on the usas
 
BigYellowIron said:
I have 2 sets of rods, one from a 95 12v and a set from a 2000 med duty truck 24v engine. Which ones would be better to put in a pulling engine.

I think the 12v ones have USA on them and the 24v ones have Mexico on them.

Any Ideas?

I'm wanting to get rid of a set of them so I want to know which ones to keep.

Thanks
Adam
Click to expand...


You should weigh them all. On the mexico rods I feel that the 700 series is the strongest. I haven't gotten a set of made in the US rods yet.
 
I have set of Cummins 6bta rods made in Japan ...:evil


They are from very early (mid '80) non turbo industrial engine.
 
I think Woodruff actually sent a cross section of all the rods out and had them tested. Call him and pick his brain im sure he will give u the lab results....
Brandon
 
I was told that the USA rods were the ones to use unless you had access to marine or industrial rods.
 
You must log in or register to reply here.
Back
Top