dvst8r Unobtainium Joined Feb 16, 2008 Messages 2,053 Feb 15, 2013 #21 I took a piece of round sch40 and just put it in the press until it was the right shape on one end. I am sure it could be done with a reasonable sized hammer and anvil as well. A torch would save your arm a bit.
I took a piece of round sch40 and just put it in the press until it was the right shape on one end. I am sure it could be done with a reasonable sized hammer and anvil as well. A torch would save your arm a bit.
not enoughsmoke floatin in tha gulf Joined Dec 28, 2008 Messages 5,730 Feb 15, 2013 #22 Keating Machine, Inc. - T6 3D Exhaust Inlet Flange, Rectangular To Round Pipe
NickTF Single turbo turd. Joined Jun 4, 2007 Messages 5,887 Feb 15, 2013 #23 dvst8r said: I took a piece of round sch40 and just put it in the press until it was the right shape on one end. I am sure it could be done with a reasonable sized hammer and anvil as well. A torch would save your arm a bit. Click to expand... We have a compressive strength testing machine we use to test concrete cylinder failure pressures which would do the job nicely should I need it!
dvst8r said: I took a piece of round sch40 and just put it in the press until it was the right shape on one end. I am sure it could be done with a reasonable sized hammer and anvil as well. A torch would save your arm a bit. Click to expand... We have a compressive strength testing machine we use to test concrete cylinder failure pressures which would do the job nicely should I need it!