SuperSonic
El Vato
- Joined
- May 31, 2006
- Messages
- 2,036
-2 sets of 01 VP rods less than 30k on them 260.00 --1 set SOLD--
-2 sets of stock 24v pistons one from 99 one from 01SO 230.00 per set.
-1 set stock 215 12valve pistons out of 1997 RV engine, low miles good shape. 200.00
-1 set Arias 12valve pistons. std bore, 11-1cr, deep flycuts, hard anodized, only four runs, piston from cyl#1 has a couple very small dings in it from injesting a chunk of mud (size of the end of a fine ball point pen). 650.00
-2 stock 24v camshafts. Less than 30k miles, in great shape, w/tappets and gears. 100.00 each.
-2 24v cylinder heads. Parent valve seats (not inserts) No cracks, low miles, both were off of stock automatic pickup trucks. 525.00 each.
-1 12valve short block. 102k miles. STORM block. comes with oil pan, gear housing, and tappet cover. Ran great when removed from truck to install hi-perf engine. 700.00
1- 24v crankshaft. great shape. 250.00
1- 12v cylinder head. 58k miles. Newer 60lb springs, no obvious cracks, checks flat. 525.00
1- VP-44 Came off a running truck with less than 30k miles, AFAIK it still works but selling for less than core. 250.00 --sale pending--
1- P7100 215 off a 97. needs AFC. Was off a running truck, but selling as core. 350.00 --sale pending--
3- stock 6.7 turbos, less than 10k on each, came off of stock running trucks. 250.00 each or all three for 650.00. come with electronics, and turbine outlet to exhaust adapter.
1- Turbonetics HP-106. 106mm comp wheel, t-6 231 turbine housing. v-band comp outlet, polished housing, ball bearing. Has not been ran since it was freshened up. 1,000.00. --SOLD--
1- s-468. Built by Scheid Diesel Service. ran as a single on my DD. has 5k miles on it since it was rebuilt. Has .8 t3 turbine hsg. 74mm turbine exducer, 4" hx40 outlet, v band flange on comp hsg to accept stock discharge elbow. 1,100.00
1- Spearco Intercooler fits 1994-2002 dodge. comes with charge air tubes, in good shape, very low miles. 980.00 --sale pending--
1- Hogan HD intercooler. Stock tanks, with heavier and better flowing core rated at 100 psi. about three years old, in great shape. 750.00
1- SBC 3250 Sprung hub DD 1-3/8, lever pressure plate, steel flywheel. Has about 10k on it. never raced or pulled, works perfect. 650.00
Axle Parts- Factory housing centers for 106 and 172 Rockwell.
Set of rockwell 106 steering knuckles (both sides)
Set of 106 front axles (5 ball design) All for 400.00
All parts are OBO, I can deliver to TS or Scheid Diesel Extravaganza, otherwise will be +shipping. I accept Paypal or cash.
Contact me here by PM or at watsonmotorsports@gmail.com.
Pictures posted by request.
-2 sets of stock 24v pistons one from 99 one from 01SO 230.00 per set.
-1 set stock 215 12valve pistons out of 1997 RV engine, low miles good shape. 200.00
-1 set Arias 12valve pistons. std bore, 11-1cr, deep flycuts, hard anodized, only four runs, piston from cyl#1 has a couple very small dings in it from injesting a chunk of mud (size of the end of a fine ball point pen). 650.00
-2 stock 24v camshafts. Less than 30k miles, in great shape, w/tappets and gears. 100.00 each.
-2 24v cylinder heads. Parent valve seats (not inserts) No cracks, low miles, both were off of stock automatic pickup trucks. 525.00 each.
-1 12valve short block. 102k miles. STORM block. comes with oil pan, gear housing, and tappet cover. Ran great when removed from truck to install hi-perf engine. 700.00
1- 24v crankshaft. great shape. 250.00
1- 12v cylinder head. 58k miles. Newer 60lb springs, no obvious cracks, checks flat. 525.00
1- VP-44 Came off a running truck with less than 30k miles, AFAIK it still works but selling for less than core. 250.00 --sale pending--
1- P7100 215 off a 97. needs AFC. Was off a running truck, but selling as core. 350.00 --sale pending--
3- stock 6.7 turbos, less than 10k on each, came off of stock running trucks. 250.00 each or all three for 650.00. come with electronics, and turbine outlet to exhaust adapter.
1- Turbonetics HP-106. 106mm comp wheel, t-6 231 turbine housing. v-band comp outlet, polished housing, ball bearing. Has not been ran since it was freshened up. 1,000.00. --SOLD--
1- s-468. Built by Scheid Diesel Service. ran as a single on my DD. has 5k miles on it since it was rebuilt. Has .8 t3 turbine hsg. 74mm turbine exducer, 4" hx40 outlet, v band flange on comp hsg to accept stock discharge elbow. 1,100.00
1- Spearco Intercooler fits 1994-2002 dodge. comes with charge air tubes, in good shape, very low miles. 980.00 --sale pending--
1- Hogan HD intercooler. Stock tanks, with heavier and better flowing core rated at 100 psi. about three years old, in great shape. 750.00
1- SBC 3250 Sprung hub DD 1-3/8, lever pressure plate, steel flywheel. Has about 10k on it. never raced or pulled, works perfect. 650.00
Axle Parts- Factory housing centers for 106 and 172 Rockwell.
Set of rockwell 106 steering knuckles (both sides)
Set of 106 front axles (5 ball design) All for 400.00
All parts are OBO, I can deliver to TS or Scheid Diesel Extravaganza, otherwise will be +shipping. I accept Paypal or cash.
Contact me here by PM or at watsonmotorsports@gmail.com.
Pictures posted by request.
Last edited: