Smarty tuning on large single

N

N8theGr8

N8
Joined
Jul 16, 2009
Messages
48
Have a early 04 with a t-70 ballbearing Turbonetics on a t4 manifold with a tial waste gate.
Running a floor it stage 3 cp3 with a wild rail and dual feed /30k bov

Flux 2.5s

Helix 2 cam
Springs studs Ect Ect built trans
Just switched to the TNT revo from the beta 4.2
Truck is stacked with a tst r49
Trying to play with tuning. Truck is a scolded dog on the top end. What are you big single guys using for tuning to pull some fuel out of the bottom end
What setting on smarty.
Should I switch to udc
New to tuning singles
Any advise is greatly appreciated
Thanks Nate
 
SSR. My brother got it for his 03 and he loves it. There is plenty of maps and tuning available with SSR to make a smoke free high HP pick up.
 
His truck has twins BTW but it is around or above 700 hp
 
My twins were nasty broke a flange and threw this on for fun. Ill have to look into this
 
I run a BW S475 with Smarty TNT and 100% over Exergys. I DD it in #5 with all settings at default. When I run at the track I use #9 with speedo set at 250, high rpm on, shift limiter off, timing on 2, rail pressure on 2, torque management on 3, and the wastegate setting off. Best run so far is 11.54@117 fuel only. Not bad IMO for ~ 4,200'.
 
You must log in or register to reply here.
Back
Top