Nor'Easter
New member
- Joined
- Nov 21, 2012
- Messages
- 947
I have a Dana 80 C&C axle that I want to use in combination with regular SRW wheels. This is to get an overall narrower track so it's proportionate to the 50s truck it's going under.
Does anyone know if this is plausible/ safe? I bolted a set of Fuel wheels I had on the other day and while everything started fine, it seemed like the center bore of the wheel was a few thousands too tight over the corresponding axle hub. I used a set of tapered lugs on the original studs and they went on fine.
I know the original dually wheels are hub centric not lug centric. Looking at aftermarket wheels, the bore is 125.2mm on both dually and SRW wheels.
Does anyone know if this is plausible/ safe? I bolted a set of Fuel wheels I had on the other day and while everything started fine, it seemed like the center bore of the wheel was a few thousands too tight over the corresponding axle hub. I used a set of tapered lugs on the original studs and they went on fine.
I know the original dually wheels are hub centric not lug centric. Looking at aftermarket wheels, the bore is 125.2mm on both dually and SRW wheels.
Last edited: