ClayKann101
Zombie Hunter
How bout a single miter.
Might go with the flat tops... because I can figure out a way to evenly cut the miters on both stacks.
Cut the bottom of the stack not the top, Or find the angle and cut them a few inches shorter at the same angle.
Then cut the top, worse case scenario is you can cut the reducer off of each stack then after you cut the stack to length weld it back up, sand smooth.Can't cut the bottom because it flares down to 5" there.
Then cut the top, worse case scenario is you can cut the reducer off of each stack then after you cut the stack to length weld it back up, sand smooth.
That might be the best scenario.. I'll prolly try that.