Which stacks do you prefer on MY truck?

[ClayKann101]

How bout a single miter.

 

[ClayKann101]

Might go with the flat tops... because I can figure out a way to evenly cut the miters on both stacks.

Cut the bottom of the stack not the top, Or find the angle and cut them a few inches shorter at the same angle.

 

[Cummin_Get_Some]

Cut the bottom of the stack not the top, Or find the angle and cut them a few inches shorter at the same angle.

Can't cut the bottom because it flares down to 5" there.

 

[SSpeeDEMONSS]

the shorter mitre cuts.

Garrett

 

[ClayKann101]

Can't cut the bottom because it flares down to 5" there.

Then cut the top, worse case scenario is you can cut the reducer off of each stack then after you cut the stack to length weld it back up, sand smooth.

 

[Cummin_Get_Some]

Then cut the top, worse case scenario is you can cut the reducer off of each stack then after you cut the stack to length weld it back up, sand smooth.

That might be the best scenario.. I'll prolly try that.

 

[ClayKann101]

That might be the best scenario.. I'll prolly try that.

Try to cover most of your stack when you reweld the reducer or your splatter will be all over your chrome stack.

 

[Cummin_Get_Some]

for those of you that said shorter then the "short miters"....

 

[Cummin_Get_Some]

 

[HOLDERDOWN]

cut down is my vote