3rdgenmike
Member
- Joined
- May 3, 2022
- Messages
- 44
I think my 48re is skipping 2nd gear and going straight to 3rd under regular driving. I have a TFRE-PRO kit installed, along with an anteater stand along controller and can't feel 3rd gear engage, I only feel/hear 2 shifts. I can manually shift the truck and feel 1-2, 2-3 and 3-4, but if I put it in drive, I only feel 2 shifts, unless I give it a little more throttle, than I can feel 3 shifts. But, the second shift happens like 2 second after the 1st shift and not when it's programmed to. If I give the truck decent throttle (over 40%), I can feel 3 shifts. I have 1-2 set at 12mph and around 14mph i can feel it shift again. Yet, it isn't supposed to shift into 3rd till 19mph. Any one got any ideas? Could it be the governor solenoid, or transducer causing this? Tv cable has been adjusted and it doesn't seem to help anything. The trans was acting fine until I put about 1200 miles on it, then the 2-3 shift slowly got softer over the months till nothing.
Also, there's no codes that pop up and under heavy acceleration, it shifts into all gears fine.
Also, there's no codes that pop up and under heavy acceleration, it shifts into all gears fine.